How to Add Water
See Filling Chart(below) for amount of water to use.
After removing funnel, proceed to Steps 4
7.
Align slot
and cap.
Dual purpose tool:
Use as wrench
to remove cap
Hold pillow upright
using a chair
Dual purpose tool:
Use as funnel
to add water
Insert base of tool in valve
cap and use as a wrench
to loosen cap. Turn tool
counter-clockwise and remove cap.
Fill pouch with a measured amount
of water to achieve desired firmness.
See Filling Chart (below) for details.
Insert tool in valve opening,
tighten and use as a funnel.
1 2 3
How to Remove Air Pocket
Now there is both water and
an air pocket in the pouch.
5
6 7
Gently push fingers down
the pillow and find
top of water level.
Gently flatten remaining portion
of pouch in a sweeping motion
to remove air pocket.
Continuing to apply light
pressure to top portion
of pouch, replace cap.
CAP
OFF
WATER
Empty water from pillow.
Hand wash in cold water
with cap on.
Do not bleach.
Hang to dry.
Do not iron.
DO NOT DRY CLEAN.
Care Instructions
Measure the correct amount of water
according to “Filling Chart” below.
FILLING CHART
DEGREE AMOUNT OF WATER
OF FIRMNESS
Ounces (quarts) Liters
Soft 60-80 oz (2 qt) 2 L
Medium 80-100 oz (3 qt) 3 L
Firm 100-130 oz (4-5 qt) 4-5 L
Use cold or lukewarm tap water. The water
temperature should not exceed 38°C or 100°F.
The water can be left in the pillow for up to
one year. Then it should be changed.
If tap water is used, no chemicals need
to be added to the water.
If well water is used, you may add a
drop of bleach to the water.
AIR
POCKET
4
How Much Water is Perfect for You?
What Type of Water
Should You Use?
May we suggest you start with a medium degree of firmness.
TOO FIRM? - Remove some water. TOO SOFT? - Add more water.
Special notice!
For best results you must remove the
air pocket from the water pouch to prevent
water from sloshing. Hold pillow upright
and follow steps 5 through 7.
If you hear sloshing when you lay your head on the pillow,
follow steps 5
7 again to remove any remaining air.
Very Important!